The drum granulator is an important part of the granulation process of the organic fertilizer production line. The drum granulator is a molding machine that can manufacture materials into specific shapes. It is suitable for large-scale production of cold and hot granulation and high, medium and low concentration compound fertilizer. Our drum granulator uses a special rubber sheet lining or acid-resistant stainless steel lining to achieve automatic mites and de-tumor, eliminating the traditional squeegee device.
Drum granulator common problems and solutions
Q: The tweezers of the drum granulator are sliding. How to solve the problem?
A: 1 The dish-shaped splicing slider is not clamped. The turntable is sandwiched between a drum type fertilizer granulator and a dish joint.
2 The disc joint and the braid are not clamped in the radial direction. You can use the bottom plate or clamp it. Note that it is over-clamped or unevenly clamped to avoid accidents.
Q: The drum granulator is in a misaligned state. How to adjust the position?
Answer: 1 The riding wheel is worn. Repair or replace the riding wheel according to the degree of wear.
2 gear wear. You can fix, remove and replace gears according to the wear rate of the drum granulator.
Q: The drum granulator gear is in a misaligned state. How to regulate its status?
A: 1 pinion is wearing. In turn install the pinion. If both sides are worn, new gears need to be replaced for rotational wear
Drum granulator maintenance
1. Drum should be wiped dry on the gear before the drum granulator is turned on;
2, wipe the surface of the belt for 7 days to dry the butter;
3. The bearing housing of the drum granulator is used every three months or replaced with new dry butter;
4. The gear oil must be added once before the reducer is used, and replaced every four months thereafter.